Abstract:
This report aims to model, simulate, perform the static and dynamic analysis and
fabrication of a go kart chassis consisting of Circular beams. Modeling , simulations are
performed using modeling software i.e. SOLIDWORKS and analysis on ANSYS. The
maximum deflection is determined by performing static analysis. Computed results will be
then compared to analytical calculation, to check whether the location of maximum
deflection agrees well with theoretical approximation.
The chassis is designed such that it requires less material and as well as it is strong
enough to withstand the various impacts on it. Strength and light weight were our basic
consideration throughout the design of the chassis of the kart. Hence, AISI1018 was selected
as an appropriate material for design which is a medium carbon steel with properties such as
light weight, high tensile strength, high machinability, better weldability, etc.
All the impacts and stresses were calculated manually by considering the severe
working conditions and then the design was analysed in the analysis software. Step by step
modifications in design were made as found necessary and as analysed on the software. After
the complete analysis and the approval of design by inspecting it in all the modes of failure
the design was finalized and was selected to fabricate which will not fail in any extreme
criteria of stresses or load induced.
